Roland 500: Problem in the firmware of the LENZE

https://drive.google.com/file/d/1MkViMUBgMqY-q4cYXOIQeaHZ23Dr1jVL/view?usp=drivesdk

 

hello,
Do you still have issues with your Lenze? or it's fixed after loading the parameters?

 

Yes, there is a problem! The video is the process of how I record the parameters in LENZE, but after recording I still have the errors listed above.

 

Yes, there is a problem! The video is the process of how I record the parameters in LENZE, but after recording I still have the errors listed above.

 

First, change the AIF plug settings parametrization as in the attached picture and try again to download the parameters.

 

second, what is the error code at the Wilma board and describe the behavior of the lenze drive.

 

Change the communication board.
Use a display. It gets easier. Copy paste. ...from another PU

ПП Поменяй язик машини, а то по руски не все понимают.

 

Swap the lenze drive with other printing unit drive

 

If this lenze is new, it may not be suitable. Take a picture of its serial number.

 

https://drive.google.com/file/d/1TNZGTre-nFmQbMsYm6qZ9L5UKrGGrsJE/view?usp=drivesdk

 

changed the drive the error went away along with the drive

 

Now the errors are as follows

 

please do step by step as attached information, you will find the problem.

 

its a new Lenze? or old that was working before and stopped then.

 

the protection guard for dampening is closed and the contactor K052 for the motor pulls in?

 

the old one who was standing and working on another section

 

I can't figure out where the X31 connector is

 

X31?

 

yes I'm talking about these signals exactly