Relocating Polar 90

At the moment i am having polar 90 at my premise and i am planning to move that to my back side store as the store entrance is small i am unable to move it fully.

Can any one advice me whether it is possible to move the polar cutter by removing the table, motors, glass and other components of the polar cutter.

Please refer to the attached images of the polar cutter.

 

yes if you know how to put back

 

Hi sir:
You can moving the polar complete, without touching nothing Only using Forklift and Wood Pallets
between the Clamp .,use Carefully and slowly.
Attached is there scheme.how to do it.

 

I have the same problem, moving polar Can i grab it under the table in front with pallets on fork lift and jack back of the table on a troley ? And is it enough to be only 10cm from the back
wall for servising ? Its polar 92 y1999. I will move it only 8 meters on leveled floor.

 

Hi sir:

You can do the same , attached is there the way , how to do it with carefully

without touching nothing Only using Forklift and Wood Pallets

Good luck

Blessing

 

I'm moving a Polar 78 out of a building that can't fit a forklift. Does anyone have experience moving one with a gantry crane?

 

Hi Sir:

Will send you details, tomorrow,now is late.

Blessings

 

Hi sir:

Attached is there as you can do it, with a gantry crane.

Good luck.

 

That s a live exemple sir

 

Polar 78 has it own lifting point on the top of the machine under the screw on top cover
It just rolls up and you can use a gantry with a block and tackle to lift.
It will lay backwards a little when lifted so you need to lift up at the back till you get a little height.
When you drop it down lift the back up at the end of the rear table and the weight will counterbalance and level machine if you don’t lift it will fall backwards
And you don’t want that happening
Rear legs should be tightened and locked up after.